Mini Cooper Countryman R60 Dashboard Removal

In order to remove a dashboard some common tool required, Small flat head screwdriver, pick tool, T30, T25 torx sockets, and 10mm long socket

Start on removal right side knee airbag, in order to reach a 10mm nut we have to remove floor light using a T25 socket

Remove a side trim on each side by pulling it with flat head screwdriver,

Left side shown, same as a right side

Remove a T30 screw and 10mm nut from opposite side

Pull it with small screwdriver out of glove box. Remove air bag and lift a top portion of electrical connector before puling it out

Remove a golve box. There is T25 screws on top and T30 Screws on bottom

.

Center console trim removes by pulling toward yourself, there is picture of clips so you see where its located so not to broke

Pull side decorative panels outward

Remove Driver side knee panel by unscrew 3 buttom T25 screws and puling whole panel toward yourself

Unbolt center panel trim and pull it few inches out, do not remove it completely

Remove a top dashboard grille,

Remove T25 screew

Pull grille upward from a rear side

Remove a 7pc T25 screew holding a panel and pull it out

Unscrew a three T25 screws holding screen, and two screws holding vents, remove vent by turning them .

Disconnect electrical connectors

Remove side trim panel

Remove round cover on A-Pillar trim

Unscrew T25 Screw

Pull A-Pillar Cover out

Unscrew a Side Vent

Under this vent at red curcle area located bolt holdiing a dashboard,

Remove bolts and connector for dash airbag

Remove tachometer

Remove 4 screws T25 holding a dashboard. Pull it upward and toward yourself

Dashboard removed